Jordis 1988 Samurai (Re)Build
-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Jordis 1988 Samurai (Re)Build
Yup, SCUK shit rubber, so many uses.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Jordis 1988 Samurai (Re)Build
So, been in the garage again tonight. Last few check before Wales.
Fuel lines changed
A transfer box oil seal changed.
Carb tweaked
CB swapped to a (hopefully) better one
Ready for the off tomorrow.
Fuel lines changed
A transfer box oil seal changed.
Carb tweaked
CB swapped to a (hopefully) better one
Ready for the off tomorrow.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
-
donkeychomp
- I spend far too much time on here
- Posts: 3582
- Joined: Thu Aug 18, 2011 3:49 pm
- Location: Shepperton, Middx
Re: Jordis 1988 Samurai (Re)Build
Have a great time mate, wish I was going...
If it ticks over...leave it
-
Anton
- I spend far too much time on here
- Posts: 3859
- Joined: Tue Jan 12, 2010 12:12 pm
- Location: London
Re: Jordis 1988 Samurai (Re)Build
Me too!
1985 SJ413VX (SJ50V) with SPOA, rear disc brakes, 31x10.5R15 Kaiman Malatesta tyres, an MOT and a lot left to do!
My: Build thread ● To-do list ● Pay and Play map
My: Build thread ● To-do list ● Pay and Play map
-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Jordis 1988 Samurai (Re)Build
1017 miles over 5 days. Several hundred to south wales, several hundred through wales, covering some awesome, scenic, tricky and brutal lanes, several hundred back home.
Overall no major issues, some tweaks to do with the body work and suspension. Worst thing was the constant leak of rear diff oil and the rear drive flanges trying to unbolt themselves.
Overall a great trip, little truck performed well and has earned some well deserved tlc. Making a start today on the smaller stuff. The less important but bigger jobs (needs sills cutting out and new ones) can wait for now.
Overall no major issues, some tweaks to do with the body work and suspension. Worst thing was the constant leak of rear diff oil and the rear drive flanges trying to unbolt themselves.
Overall a great trip, little truck performed well and has earned some well deserved tlc. Making a start today on the smaller stuff. The less important but bigger jobs (needs sills cutting out and new ones) can wait for now.
Last edited by Jordi on Thu May 23, 2019 6:17 pm, edited 1 time in total.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Jordis 1988 Samurai (Re)Build
1st job done was to move the back axle forward an inch. Easy enough as the bolt hole was already in the bracket.
When fully loaded it was literally sat on the stops and the shackle angle was very shallow.
Looks much healthier.
When fully loaded it was literally sat on the stops and the shackle angle was very shallow.
Looks much healthier.
Last edited by Jordi on Thu May 23, 2019 6:36 pm, edited 1 time in total.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Jordis 1988 Samurai (Re)Build
Flexed it up.
- Attachments
-
-
-
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Jordis 1988 Samurai (Re)Build
Had more to offer so added another 6” block under the ramps.
- Attachments
-
-
-
-
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank