Re: Jordis 1988 Samurai (Re)Build
Posted: Sun May 12, 2019 2:38 pm
Can't beat a bit of shit belt
Suzuki Club UK
Home of all things Suzuki 4x4
https://suzukiclubuk.co.uk/forum/phpBB3/
Jordis 1988 Samurai (Re)Build
https://suzukiclubuk.co.uk/forum/phpBB3/viewtopic.php?t=1545
Page 81 of 85
Re: Jordis 1988 Samurai (Re)Build
Posted: Sun May 12, 2019 3:27 pm
Yup, SCUK shit rubber, so many uses.
Re: Jordis 1988 Samurai (Re)Build
Posted: Fri May 17, 2019 11:44 pm
So, been in the garage again tonight. Last few check before Wales.
Fuel lines changed
A transfer box oil seal changed.
Carb tweaked
CB swapped to a (hopefully) better one
Ready for the off tomorrow.
Fuel lines changed
A transfer box oil seal changed.
Carb tweaked
CB swapped to a (hopefully) better one
Ready for the off tomorrow.
Re: Jordis 1988 Samurai (Re)Build
Posted: Sat May 18, 2019 12:27 am
Have a great time mate, wish I was going...
Re: Jordis 1988 Samurai (Re)Build
Posted: Sat May 18, 2019 7:08 pm
Me too!
Re: Jordis 1988 Samurai (Re)Build
Posted: Thu May 23, 2019 8:01 am
1017 miles over 5 days. Several hundred to south wales, several hundred through wales, covering some awesome, scenic, tricky and brutal lanes, several hundred back home.
Overall no major issues, some tweaks to do with the body work and suspension. Worst thing was the constant leak of rear diff oil and the rear drive flanges trying to unbolt themselves.
Overall a great trip, little truck performed well and has earned some well deserved tlc. Making a start today on the smaller stuff. The less important but bigger jobs (needs sills cutting out and new ones) can wait for now.
Overall no major issues, some tweaks to do with the body work and suspension. Worst thing was the constant leak of rear diff oil and the rear drive flanges trying to unbolt themselves.
Overall a great trip, little truck performed well and has earned some well deserved tlc. Making a start today on the smaller stuff. The less important but bigger jobs (needs sills cutting out and new ones) can wait for now.
Re: Jordis 1988 Samurai (Re)Build
Posted: Thu May 23, 2019 8:57 am
Re: Jordis 1988 Samurai (Re)Build
Posted: Thu May 23, 2019 6:19 pm
1st job done was to move the back axle forward an inch. Easy enough as the bolt hole was already in the bracket.
When fully loaded it was literally sat on the stops and the shackle angle was very shallow.
Looks much healthier.
When fully loaded it was literally sat on the stops and the shackle angle was very shallow.
Looks much healthier.
Re: Jordis 1988 Samurai (Re)Build
Posted: Thu May 23, 2019 6:24 pm
Flexed it up.
Re: Jordis 1988 Samurai (Re)Build
Posted: Thu May 23, 2019 6:26 pm
Had more to offer so added another 6” block under the ramps.