Lift shackles, what's the maximum lift?

[Jay18]

i plan on using a centre punch, not going to just drill a hole and hope it works lol, will check and double check that its right before drilling holes in my axle perches and bottom plates..

[Jordi]

2013-08-17-1093.jpg (483.85 KiB) Viewed 4200 times

Just thought I'd post a pic of my arch gap.

[Jay18]

when ive got this sorted and got the 5 speed in ill take the zuk up wigan pay and play and get some mud on it lol, need to do the gearbox soon as i think the clutch is on its way out as when the engine is idling i can get something being flung around the bell housing or the gearbox, so its t=either bits of gears in the box or the clutch, ive got both in the shed so its just a case of getting round to doing it lol..

[Jordi]

The release bearing might be collapsing.

Not sure about the 4 to 5sp conversion but even an amateur should be able to do the clutch in under 2hrs.

[turbo-tom]

out of interest jordi do they catch ?

[Jordi]

out of interest jordi do they catch ?

Very slightly on the bulkhead, in every position I'v had it you can slide your hand between the wing and tyre (once you've scraped the mud out)

[turbo-tom]

ahh just looks like it does! but looks phatt though!

[Jordi]

I was concerned first few times out but there's no tyre damage, no scuff marks in the wing and when I've had it as in the pic I've checked it a few times. All seems good.

[ScottieJ]

As long as the inner wings are nice and smooth where they hit then there's no need to worry about a bit of rubbing

[donkeychomp]

8 nuts and drill 4 holes

Do you have 8 mates to help move the axle?