Lift shackles, what's the maximum lift?

[Jay18]

i think the bumpstops are standard, maigh have a go at moving the axle tomorrow then..

[dan_2k_uk]

Just move the damn axle already!

[ScottieJ]

lol scott I love your face in that pic.... its a classic "expecting mud spray" look!

Might be something to do with the fact I was getting covered in spray

[Jay18]

okay! ill move the axle! hahaha shouldnt take long should it?

[dan_2k_uk]

8 nuts and drill 4 holes

[ScottieJ]

i think the bumpstops are standard, maigh have a go at moving the axle tomorrow then..

try it, flex it up on full lock and see what happens.

[Jay18]

im guessing its just a case of remove calipers and hang them up, remove bottoms of the shocks, remove u bolts, remove shackle bolts and pull the axle out and drill the holes? then slap it back together in the new holes?

[ScottieJ]

Yes, make sure you measure from the original holes though and not the edge of the perches on the axle as they are different lengths.

Measure twice (or 4 times) and drill once, last thing you want is a wonky axle

[Jay18]

right okay mate, will see what i can do tomorrow...

do you know the size of the hole? i can find out when i strip it tomorrow but will make it a bit easier if i know now..

[ScottieJ]

Think they are 12/13mm it's been a while though. Also dont forge to centre punch before you drill to stop the drill bit walking and keep everything accurate.