Removing Gearbox From A Vitara, WITHOUT A RAMP!!

The place to socialise, and relax, if it doesn't fit into anything below it fits here, so tell us that joke, or share that story of your last off-road escapade, but remember new comers the virtual drinks are on you!
Post Reply
User avatar
rory-ray
Engaged 4wd low
Engaged 4wd low
Posts: 101
Joined: Sun Aug 04, 2013 11:04 pm
Location: Bristol

Removing Gearbox From A Vitara, WITHOUT A RAMP!!

Post by rory-ray » Fri Aug 30, 2013 11:08 pm

Ok

Me and my mate had to take the 16v engine out one of the vitara's were breaking, engine was a doddle, disconnected everything ready to be separated from the gearbox, undone the bolts connecting the box to the block and it DID NOT move. A hour of scratching our heads, a few smacks with a persueder and a slight bit of stress starting to show we devised a plan.

Bolted the engine back onto the mounts and done this......

Image

Image

Image

Image


After this was done the box was unbolted and removed, car pushed back over and engine removed no problems!
1994 Pick Up Converted Vitara



+2" Springs, Pro Comp Front And Rear Shocks, 31" Marshalls On 8j's, Front Winch Bumper, OMP Steering Wheel And Boss, Bucket Seats, Stripped Out, Black Bonnet With Scoop, Few Dents And Scratches, Little Rust!!!

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Removing Gearbox From A Vitara, WITHOUT A RAMP!!

Post by turbo-tom » Fri Aug 30, 2013 11:10 pm

Thats certainly the right way to remove a engine from that green vit. Atleast it wont be powering that anymore! :hahaha:
Tom :)

Ford Fiesta ST :D

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Removing Gearbox From A Vitara, WITHOUT A RAMP!!

Post by Jordi » Fri Aug 30, 2013 11:16 pm

I recognise that "why do you want ramps? Just roll it on it's side method". The thinkings mans way to solve a problem :hahaha:
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
donkeychomp
I spend far too much time on here
I spend far too much time on here
Posts: 3582
Joined: Thu Aug 18, 2011 3:49 pm
Location: Shepperton, Middx

Re: Removing Gearbox From A Vitara, WITHOUT A RAMP!!

Post by donkeychomp » Fri Aug 30, 2013 11:34 pm

:hahaha:
If it ticks over...leave it

User avatar
kiwizook
SCUK Addict
SCUK Addict
Posts: 879
Joined: Fri Dec 28, 2012 2:36 am
Location: Masterton, NZ

Re: Removing Gearbox From A Vitara, WITHOUT A RAMP!!

Post by kiwizook » Sat Aug 31, 2013 1:41 am

:hahaha: :hahaha:

what was the body like after you rolled it back?
It's not a question of how much you spend on your suzuki, but when your money will run out

Post Reply