Project back in black.
- robbie1985
- Engaged 4wd low
- Posts: 111
- Joined: Mon Jan 12, 2015 8:10 pm
- Location: Portsmouth
Re: Project back in black.
i've been working to rid the car of rust, so have been busy with the wire brush, krust, and red oxide. before the really horrendous weather kicked in i managed to get some of the worst of the rust on the back end dealt with and also done the tank guard which came out really well, i finished it off with halfords truck bed paint i was a bit skeptical about it and to be honest i was really impressed, i'm probably gonna use it in the the car in the foot wells and the back of the truck once i have removed the rust and welded in good metal around the old seat belt mounts. i am gonna be buying a 3 inch body lift from b4v in the near future and whilst fitting that i will go through the hole chassis and under the body and do the same with any rust i find. tis all fun
- Attachments
-
- IMAG0521 (Small).jpg (182.64 KiB) Viewed 5721 times
-
- IMAG0522 (Small).jpg (169.67 KiB) Viewed 5721 times
-
- IMAG0523 (Small).jpg (213.78 KiB) Viewed 5721 times
-
- IMAG0524 (Small).jpg (161.44 KiB) Viewed 5721 times
-
- IMAG0525 (Small).jpg (154.32 KiB) Viewed 5721 times
-
- IMAG0527 (Small).jpg (133.55 KiB) Viewed 5721 times
-
- IMAG0528 (Small).jpg (126.49 KiB) Viewed 5721 times
-
- IMAG0529 (Small).jpg (141.35 KiB) Viewed 5721 times
-
- IMAG0530 (Small).jpg (144.45 KiB) Viewed 5721 times
- robbie1985
- Engaged 4wd low
- Posts: 111
- Joined: Mon Jan 12, 2015 8:10 pm
- Location: Portsmouth
Re: Project back in black.
i am also looking for a set of bull bars like these, if anyone has a set that they want rid off?
- Attachments
-
- Picture011 (Small).jpg (80.21 KiB) Viewed 5720 times
Re: Project back in black.
Tidy job that mate fair play.
I literally spent 5 mins wire brushing my tank gaurd off then rollered some hammerite over it haha
I literally spent 5 mins wire brushing my tank gaurd off then rollered some hammerite over it haha
- robbie1985
- Engaged 4wd low
- Posts: 111
- Joined: Mon Jan 12, 2015 8:10 pm
- Location: Portsmouth
Re: Project back in black.
To be honest that's all I was gonna do it it, but I had the spray paint and wanted to se e what it came out like before I used in it the foot wells.
- donkeychomp
- I spend far too much time on here
- Posts: 3582
- Joined: Thu Aug 18, 2011 3:49 pm
- Location: Shepperton, Middx
- robbie1985
- Engaged 4wd low
- Posts: 111
- Joined: Mon Jan 12, 2015 8:10 pm
- Location: Portsmouth
Re: Project back in black.
Cheers donkey chomp, I am gonna drop the fuel tank out so I can get to the back of the crossmember and clean up the tank. I have a list the length of my arm of thing I wanna do under the car but can't take it off the road for long enough to do it all at once'