hi rear wheel bearings easy or hard 2 replace

carlsush · Post by **carlsush** » Tue Sep 10, 2013 11:58 pm

r rear wheel bearings hard 2 do on a suzuki samurai

turbo-tom · Post by **turbo-tom** » Wed Sep 11, 2013 12:27 am

Nope. Ideally you need a press.

Post by **timwilks13** » Wed Sep 11, 2013 1:38 am

Only done em on a 410, if they are similar then ideally a press is good, otherwise an angle grinder and metal chisel will get em off and some scaffolding bar and some force will put em back. Don't clamp the bearing in a vice and hit the half shaft though to get em off, can damage the teeth at the end doing that!

carlsush · Post by **carlsush** » Wed Sep 11, 2013 7:34 am

looks likethe grinder will do the job then

Post by **Jordi** » Wed Sep 11, 2013 8:19 am

Cut the off with a grinder and can be persuaded back on.

Post by **ScottieJ** » Wed Sep 11, 2013 9:12 am

http://www.suzukiclubuk.co.uk/diy/18-wh ... l-bearings

carlsush · Post by **carlsush** » Wed Sep 11, 2013 3:15 pm

thanks 4 the help

carlsush · Post by **carlsush** » Wed Sep 11, 2013 7:19 pm

just got a axle 4 40 quid so win win

Suzuki Club UK

hi rear wheel bearings easy or hard 2 replace

hi rear wheel bearings easy or hard 2 replace

Re: hi rear wheel bearings easy or hard 2 replace

Re: hi rear wheel bearings easy or hard 2 replace

Re: hi rear wheel bearings easy or hard 2 replace

Re: hi rear wheel bearings easy or hard 2 replace

Re: hi rear wheel bearings easy or hard 2 replace

Re: hi rear wheel bearings easy or hard 2 replace

Re: hi rear wheel bearings easy or hard 2 replace

test