Page 1 of 1
bull bar fitting help pls
Posted: Wed Aug 14, 2013 8:31 pm
by coupedriver
After Luke very kindly donated me some bull bars I took this afternoon off to fit them,but no joy,can't find where they attach to,do I have to remove the front bumper for them to fit,or am I just missing some brackets,they do line up with the a arm mount but are about 10 inches away,or am I better off welding brackets to the frame rails,some pics so you can see my problem.
- IMAG1205.jpg (1.12 MiB) Viewed 6126 times
- IMAG1206.jpg (956.71 KiB) Viewed 6126 times
Re: bull bar fitting help pls
Posted: Wed Aug 14, 2013 9:48 pm
by rory-ray
have you got any pictures of them front on? on my white vitara they were cut into the bumper and sat on the outside of the chassis legs, these look like they will fit the same im not 100% but they look a very simuler fitment
Re: bull bar fitting help pls
Posted: Wed Aug 14, 2013 10:03 pm
by coupedriver
Sorry for my ignorance but what do you mean by chassis legs???
Re: bull bar fitting help pls
Posted: Wed Aug 14, 2013 10:14 pm
by rory-ray
Don't worry mate, I just studied the photos a bit better.
you will need brackets, the bars look like they may of been from a long wheel base vitara so wont bolt up to yours, or there from a short wheel base vitara and you got a long wheel base one?
Re: bull bar fitting help pls
Posted: Wed Aug 14, 2013 10:15 pm
by turbo-tom
When you look down in the engine bay. Each side of the engine bay you will see "box" section either side of the engine. And also it will be close to the other side of the wings.
Re: bull bar fitting help pls
Posted: Wed Aug 14, 2013 10:33 pm
by coupedriver
Mine is swb,they line up with the inside of the,is it,bottom wish bone mounts,exactly.am I better welding mounts to there or the "box" section/chassis rails,going to notts sunday to visit father in law who's a pro welder,so can get him to do it,which one is better to weld to.Thankyou