Suzuki Club UK

So this has confused me of how to get it off ??

the spacer itself should pull off then you can unwind the studs after. if its stuck on give it a good squirt up with wd40 or the equivalent and leave to soak in for a bit and try again

oh okay i think they may be stuck then as they have been soaked in clay thanks

How do i get these bits of now ??

With a bar put across 2 and levering against the floor to stop the hub spinning just use a deep socket or a ring spanner.

Or get someone to put their foot on the brake

or get a rattle gun and buzz them off!

Nearly done them all with an adjustable and a nice slice out of my finger

Bleeding it all part of the experience Ollie. By the end of the week i'll lucky to have skin on my hands.

Ollie you want to get yourself a decent socket set and set of spanners (at least 8-19mm) before you buy any more parts, adjustable spanners shouldn't go anywhere near a vehicle unless its an emergency, they are aweful things and spend most of their life rounding off bolts rather than undoing them, I've got a large selection of adjustable spanners and I can't actually remember the last time I used one

Oh and this should be in wheels, tyres and brakes not the bar