Page 1 of 1

More parts homeward bound

Posted: Sat Mar 02, 2013 1:23 pm
by Jordi
My haul from grantham. Axles, calipers, engines, springs and loads of bits
image.jpg
image.jpg (2.81 MiB) Viewed 4793 times

Re: More parts homeward bound

Posted: Sat Mar 02, 2013 1:26 pm
by turbo-tom
nioce :guns:

Re: More parts homeward bound

Posted: Sat Mar 02, 2013 1:35 pm
by Jordi
Only really wanted the springs and some axle bits but the chap wanted it gone in a job lot. Will be sticking some gear up for sale asap.

Re: More parts homeward bound

Posted: Sat Mar 02, 2013 1:42 pm
by turbo-tom
fare enough! atleast you can sell some bits to gain a bit of dollar back,

thinking if which i need to sell some bits its got to that point were you cant get in the workshop :lol:

Re: More parts homeward bound

Posted: Sat Mar 02, 2013 9:14 pm
by ScottieJ
Just a few bits then :lol:

Re: More parts homeward bound

Posted: Sat Mar 02, 2013 9:19 pm
by Jordi
Yeah, just a few odds n sods Scottie. Some for the Sammi, some for the KJA, some to sell.

2 euro pallet crates full, plus 2 engines and gear boxes and 2 front and 2 rear axles.

Need to sort through it and get it all stored away.

Back to work at 12 tomorrow though

Re: More parts homeward bound

Posted: Sat Mar 02, 2013 10:05 pm
by Jordi
image.jpg
image.jpg (1.89 MiB) Viewed 4741 times

Re: More parts homeward bound

Posted: Sun Mar 03, 2013 9:25 am
by justaddmud
I was motoring that auction and did think about bidding however i would have needed to hire a van as i don't think even the cavernous boot on my Skoda estate could do all that.

was a good haul, and i can imagine you would easily make you money back parting stuff out.

Ian

Re: More parts homeward bound

Posted: Sun Mar 03, 2013 9:31 am
by Jordi
Yeah, i've stuck a load of gear for sale already. I'll give it a week or so on here. Then it'll be ebay. Then it'll be weighed in.

Was a good amount of gear. Would of needed a biggish van. I filled the back of the pickup. Some heavy gear there too, was interesting getting it as close to the house as possible and trying to poke the crane as far into the yard as possible.

I only really wanted the springs, front axle, more calipers, flexi pipes.

Engines and gearboxes just wont shift.