So i got the pick up, we're calling that the wifes gift.
The power steering gubbins has arrived today. I've been and collected my bucket seats. And for good measure a highe output alternator. Couldn't find a 70amp. But did find a cheap 55amp. Think it will be a direct swap like the transit.
Jordi
Christmas come early!!!
- Jordi
- Bow down before me
- Posts: 7534
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Christmas come early!!!
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
- Edweird
- Suzuki, will you marry me?
- Posts: 2531
- Joined: Sat Jan 23, 2010 11:04 pm
- Location: Brigg, North Lincolnshire
Re: Christmas come early!!!
You woman!Jordi wrote:The power steering gubbins has arrived today.
There's three ways of doing things:
The right way,
The wrong way
And my way, which is like the wrong way but faster.
The right way,
The wrong way
And my way, which is like the wrong way but faster.
Re: Christmas come early!!!
Haha you wouldn't say that if you drove mine with no power steeringEdweird wrote:You woman!Jordi wrote:The power steering gubbins has arrived today.
sounds like the zuki presents are flying in! Looking forward to some build thread updates! I start work on the lWB next weekend did some more poking today and Ive now got a bit of a hole in the drivers footwell
- Jordi
- Bow down before me
- Posts: 7534
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Christmas come early!!!
Yeh. Gifts are coming think and fast. Lots to be getting on with.
Need to phone Dave and order springs tomorrow. The next two months should see some major improvements.
Rockwatt should also be set up in his new workshop after christmas so hopefully february will be rocklobster time.
Also got my recovery eyes to finish.
Loads to do.
I'll get some photos and build thread updating done tomorrow once i've sorted through all the stuff.
Jordi
Need to phone Dave and order springs tomorrow. The next two months should see some major improvements.
Rockwatt should also be set up in his new workshop after christmas so hopefully february will be rocklobster time.
Also got my recovery eyes to finish.
Loads to do.
I'll get some photos and build thread updating done tomorrow once i've sorted through all the stuff.
Jordi
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank