Hi… I’m new to Suzuki Club, just purchased Suzuki Vitara 1.6 2015…
First thing I’ve done is replace the number plates with nice pristine new ones.
I don’t like ugly screw head protrusions spoiling nice flush plates so I prefer to fix plates to my cars using the double-side sticky tape/pads.
Rear plate sticks fine. Nice and solid. But front plate fell off within few hours even though car stationary throughout that period.
So I’m wondering if there’s some kind of non-stick coating on the front bumper which prevents the sticker staying on?
Does anyone have any knowledge on this, and/or advice (other than… just screw it on)?
Thanks in advance for any thoughts.
Philip.
Stuck-on front number plate falls off
-
Jordi
- Bow down before me
- Posts: 7534
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Stuck-on front number plate falls off
Try a different brand of double sided tape.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Re: Stuck-on front number plate falls off
I use the No More Nails tape and my plate has been attached for 6 years.
Re: Stuck-on front number plate falls off
You must ensure that the double-sided tape is for outdoor use.
3M do a tape with red backing that is for sticking plastic moldings and trim to side panels and doors...it's very good.
3M do a tape with red backing that is for sticking plastic moldings and trim to side panels and doors...it's very good.
Re: Stuck-on front number plate falls off
Agree with KerryJim, a good brand of sticky pads should do it. Used them on my old Seat Leon with no issues