Page 1 of 2
What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 3:19 pm
by gamble63
Not as exciting as it sounds unfortunately, cranked the engine over and oil came out, so ive obviosuly forgot to put something back in, was thinking maybe oil pressure sensor or temp?
Any ideas, i also cant find what ever it was in my box of re build bits so where would i buy one?
Cheers
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 3:30 pm
by Jordi
Oil pressure switch
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 4:03 pm
by gamble63
Cheers Jordi, would that be one of these badboys
http://www.ebay.co.uk/itm/Variant2-Inte ... 2c909a79f8
is that just there to turn a light out on the dash to say you have oil pressure?
Cheers
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 4:49 pm
by Jordi
Pretty much. Not sure if thats the right one.
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 5:39 pm
by gamble63
hahah but the ebay add says will fit 1.3 sj haha
i mean why would the possibly lie on ebay haha
any idea of a correct place?
cheers dude
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 5:47 pm
by Jordi
I usually just go to my local motor factors.
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 5:59 pm
by gamble63
cool tools
cheers dude.
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 8:19 pm
by ScottieJ
I hope you didn't thread that bolt in tightly.
It's a 1/8 bspt thread on the sender so if you did you might have damaged the thread in the block.
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 8:51 pm
by Jordi
ScottieJ wrote:I hope you didn't thread that bolt in tightly.
It's a 1/8 bspt thread on the sender so if you did you might have damaged the thread in the block.
Seriously? How do you know this shit?
I was just pleased i beat everyone to the correct answer.
Re: What was i ment to put in this hole ;)
Posted: Mon May 04, 2015 9:08 pm
by dan_2k_uk
Jordi wrote:ScottieJ wrote:I hope you didn't thread that bolt in tightly.
It's a 1/8 bspt thread on the sender so if you did you might have damaged the thread in the block.
Seriously? How do you know this shit?
I was just pleased i beat everyone to the correct answer.
Anyone who has tried to fit and aftermarket pressure gauge would know
