Page 1 of 1
sj 413 bodywork
Posted: Tue Nov 18, 2014 9:29 pm
by Gaz1783
The inlet elbow on our weber carb. is stopping the bonnet closing properly and rubbing through. Does anyone out there know if there is a small power bulge available , so we can cut through the bonnet and weld it on to give clearance for the inlet elbow.?? Thanks in anticipation Gaz,s dad.
Re: sj 413 bodywork
Posted: Tue Nov 18, 2014 9:35 pm
by gamble63
Can you not make a simple one out of sheet metal if you want to weld it on or have you tried looking on ebay for a cheap fiberglass one you can rivet on?
cheers
Re: sj 413 bodywork
Posted: Tue Nov 18, 2014 11:49 pm
by donkeychomp
Local motor factors has them, ebay etc. Do not cut a hole in the bonnet!