Suzuki Club UK

Got a samurai gear stick and gears seem all over the place still drives ok but selecting gears bit iffy any help wood be good

The machined end has probably snapped off the little locating bolt on the gearbox.

Take the gator off and Just where the lever enters the gearbox there is a 12mm bolt on the back, remove that and try to fish the machined end out. Sometimes has a bit of thread left so on need to try and twist it out....if you can't get it out that way you can remove the lever but be careful to not let the broken bit fall into the gearbox.

Replacement bolts are cheap from Suzuki or you can get the end of a bolt machined down.

Think it was about £3 from Suzuki.

Thanks give it a go this evening

ScottieJ wrote:Take the gator off

Make sure you remove the gator before you remove the gaiter

Gonna need a bigger screwdriver for that .is it the lever locating bolt that i need £1.90 but I need to go and pay before they order it in case I bankrupt them maybe.

twiss wrote:

ScottieJ wrote:Take the gator off

Make sure you remove the gator before you remove the gaiter

har har har har har

Managed to drop end in but with aid of halfords magnet on stick and a bit of luck fished it out now just to purchase said nut . To be continued

Mission accomplished thanks for your help

did you remember to refit the alligator?