Page 10 of 13

Re: Dan_2k_uk's super shed thread!

Posted: Tue Oct 22, 2013 9:03 pm
by Jordi
So will it have additional cider storage?

Re: Dan_2k_uk's super shed thread!

Posted: Tue Oct 22, 2013 9:08 pm
by turbo-tom
looking rather large and posh!

Re: Dan_2k_uk's super shed thread!

Posted: Thu Oct 24, 2013 8:09 am
by dan_2k_uk
Very productive day yesterday.

Finished cutting the last few roof panels and got it all totally fixed down.

Then got all the felt on. Sealant between all the joints and under / ontop of every nail.

Had to go grab an extra sheet of OSB in the Zook. Think 8'x4' is the full carrying capacity for an SJ :D

Luckily I had a mate round to help as the felting would have been a nightmare on my own.

I still need to add a few rows of tacks from front to back to make it extra secure but at least for now the roof is protected.


Image


Image


Image


Image

Re: Dan_2k_uk's super shed thread!

Posted: Thu Oct 24, 2013 10:29 am
by Anton
Proper job!!!

Superb mate. Want!

Re: Dan_2k_uk's super shed thread!

Posted: Thu Oct 24, 2013 2:11 pm
by Jordi
Proper tidy job Dan.

Re: Dan_2k_uk's super shed thread!

Posted: Sun Oct 27, 2013 8:11 pm
by dan_2k_uk
Started the cladding. Realised I wasn't going to get enough done to make it secure down the sides before tonight so turned my attention to the roof off and got it all tucked up and fixed under the frame and battened down the hatches for tonights storm.

Door and window blanked off with leftover roofing felt and the sides that are exposed above the fence blanked with scrap OSB to try keep the impact of the wind to a minimum.


Image


Image


Image

Re: Dan_2k_uk's super shed thread!

Posted: Sun Oct 27, 2013 8:16 pm
by turbo-tom
Looks very pro i must say! is that the only window your going to put in? presume your going to run power to it?

Re: Dan_2k_uk's super shed thread!

Posted: Sun Oct 27, 2013 8:16 pm
by dazerede
Looks good Dan u have done a nice job on the shed

Tom we have a car battery in are shed and that powers one light in are shed tbh we never use it I only used it once when I was trying to get my bearing off my shaft as that's where the vice was

Re: Dan_2k_uk's super shed thread!

Posted: Sun Oct 27, 2013 8:19 pm
by Rhinoman
That's looking good, I do hope that it comes to no harm.

Re: Dan_2k_uk's super shed thread!

Posted: Sun Oct 27, 2013 8:20 pm
by dan_2k_uk
Yeah that's the only window.

Of course it will have power to it. Can't have a man cave without tunes and a welder.