Page 5 of 6
Re: LJ80 Build
Posted: Sat Aug 08, 2009 9:43 pm
by Simon
liljitjit wrote:wow what a truck! and some of the others in photos arnt to shabby neither!. right enough ass kissing , question for you where did you get your front and rear glass made and were they dear?
Rich
Thanks mate, I had the glass made by a company called SiteGlass, there based in the South East of Kent
Re: LJ80 Build
Posted: Sun Aug 09, 2009 11:20 am
by liljitjit
cheers for , a bit far for me tho, but i take it by the name they are a plant glaziers ? I thought about that route for my front screen . if thats the case i will give my local boys a ring.
cheers.
rich
Re: LJ80 Build
Posted: Sun Aug 09, 2009 3:47 pm
by Simon
Yeah they mainly do big machinery, what have you got SJ?
Re: LJ80 Build
Posted: Sun Aug 09, 2009 9:45 pm
by liljitjit
yes mate i have a samurai if you see othe rpost you will notice i dont have any luck with glass!
just thought plant glazier could cut one to fit and that way i no its a new one!
rich
Re: LJ80 Build
Posted: Mon Aug 10, 2009 8:45 am
by Simon
SJ glass is still available mate, you could have it replaced under your insurance
If you have got full comp insurance it should only be about £60
Re: LJ80 Build
Posted: Tue Aug 11, 2009 1:37 pm
by ScottieJ
well perhaps I should come along when you next go then eh!
I just posted a question on raging rhinos about how you do your rear axle & coil conversions as i might end up going down this route now????
Re: LJ80 Build
Posted: Thu Aug 13, 2009 6:02 pm
by liljitjit
lol@ simon , its been sat in the garage for nearly 2yrs! no tax or test and no insurance, hence why need a cheap screen , ill find one soon again i think.
rich
Re: LJ80 Build
Posted: Sat Aug 29, 2009 1:27 pm
by eggwheat
Big LJ with all those crazy mods? That has to be Leigh from Dover's work!! (plus I recoginise his workshop when the body is been made wider etc)
Re: LJ80 Build
Posted: Tue Dec 01, 2009 7:32 pm
by TAZ
Hi mate that is one fantastic LJ I want on
few questions with regards to the fitting of the V6, Do you reckon it would fit it in a suzuki sj with out widening the whole truck??
Do the V6 diff's just pop into the sj axles??
What mods are required for the chassis to get the V6 and the gearbox to fit??
The wiring for the V6 was it straight forward or something that I could do?? (im ok on wiring not the best but ok)
Once again what an amazing build!!!
Luke
Re: LJ80 Build
Posted: Tue Dec 01, 2009 8:11 pm
by d86
taz may i draw your atention to this thread.
http://www.suzukiclubuk.co.uk/phpBB3/ph ... =19&t=1448
the blue one hd a 2.9 v6 ford engine on sammy axels.
tony
