Suzuki Club UK

I might try taking the caliper off my car tomorrow and do what Anton said take the piston out and clean it

If I clamp my mole grips on the ruber brake pipe so it doesn't leak brake fluid when I put the caliper back on Do I have to bleed all the brakes again or just the one I clamped as my dad is quite busy so he can't help me bleed them

If all you do is remove the one caliper and don't lose too much fluid only the one will need bleeding. If it sucks air into the reservoir the whole system will need bleeding.

Ok Chears jordi

Just rebuilt the drivers side front caliper and all is working great I will rebuild the other caliper soon as as.
I use my zook daily to get to work and might have a few days off

Also got a new sticker

Just fitted a rev gauge in my sj all wired up and working

A vid http://www.youtube.com/watch?v=bOyfKXRj ... ata_player

Also my zook is doing roughly 24mpg

well done mate! good bit of kit aren't they? what does yours do at 50mph in 5th?

It does about 5000 revs my zook needs a 6th gear lol

Also my zook is doing roughly 20 mpg lol but I did do a lot of greenlaning so that could be why

Might just have 1 week of being sensible with no offroading and will put my alloys on to see how high I can get my mpg

hmm mine does about the same in 4th :/ do you have the switch on the back of the rev counter switched to 4? might have to make sure mine is right lol
mine does about 20mpg haha so she needs a tune up and timing and then getting the £50 electronic ignition kit..

Yep its switched to 4 cylinders unless It moved when I pushed the gauge in
Did u have to exstend some of the wires on the gauge as I had to