Page 34 of 97
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Fri Apr 12, 2013 9:32 pm
by mike harris
The winch is amazing.
I am contemplating asking it if I can take it out to dinner
Mike
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Fri Apr 12, 2013 9:55 pm
by Jordi
mike harris wrote:The winch is amazing.
I am contemplating asking it if I can take it out to dinner
Mike
Shooting a bit above your league i'd say.
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Wed Apr 17, 2013 9:46 pm
by mike harris
Well took the winch apart today, it's like new inside !!
Built one hub up ready as well.
Needs a prop uj as well ones seized.
If I get an axle this week should be ok.
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Thu Apr 18, 2013 11:41 pm
by Jordi
mike harris wrote:Well took the winch apart today, it's like new inside !!
Built one hub up ready as well.
Needs a prop uj as well ones seized.
If I get an axle this week should be ok.
Is this all parts of further modification?
Or just replacing the bits you broke?
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Fri Apr 19, 2013 8:54 am
by mike harris
Front winch I am upgrading to an 8274, bought some giglepin upgrades yesterday and a winch troff to mount it in
The rear axle was was bent so I bought another one and a load of axle trusses from America with new saddles. I've fitted better rear shackles as well, again from America.
I am going to put my front winch that's on t now on the back, so it pokes through the rear door.
Got a new rad for it and new rear calipers so it can have vented brakes all round now too.
I need to find a Subaru impretza master cylinder though as my brakes are rubbish as the the master cylinder isn't big enough. Scooby one is a straight swap.
Mike
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Fri Apr 19, 2013 8:58 am
by mike harris
Made this too ....
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Fri Apr 19, 2013 9:43 am
by turbo-tom
mike harris wrote:Made this too ....
I like that.
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Fri Apr 19, 2013 10:21 am
by mike harris
I snapped a snap on file months ago, snap on wouldn't replace it as I stood on it.
So I unwound the handle and used it as a gear knob
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Fri Apr 19, 2013 10:23 am
by ROBBIE
Ahh so it's a gear knob can't tell on my phone
Re: Mikes Samurai build updated 03/01/2013 :)
Posted: Fri Apr 19, 2013 11:26 am
by kiwizook
that's really cool, will be tough filing though
