Re: Project Bodge
Posted: Mon Apr 14, 2014 11:33 am
Looks like nice tidy work bud.
You keeping the 413 diff ratios or going lower?
You keeping the 413 diff ratios or going lower?
Home of all things Suzuki 4x4
https://suzukiclubuk.co.uk/forum/phpBB3/
https://suzukiclubuk.co.uk/forum/phpBB3/viewtopic.php?t=2070
dan_2k_uk wrote:Good stuff.
I need to make a jig just like that to truss mine and add YJ perches.
What size box section is that you are using for that truss. Looks the perfect size.
I'll be using the 413 diffs for the time being. May have to change them at some point if i end up getting chromo shafts or some kind of diff lock in the futuerJordi wrote:Looks like nice tidy work bud.
You keeping the 413 diff ratios or going lower?
Could you fill it with expanding foam?Jordi wrote:Looks real tidy. Not sure about all the holes in them?
Take it you're just going to spray/pour/force paint into them all when it's welded up?
That would just soak up water, wouldn't it?Ladaman wrote:Could you fill it with expanding foam?Jordi wrote:Looks real tidy. Not sure about all the holes in them?
Take it you're just going to spray/pour/force paint into them all when it's welded up?
That would keep the crap out, or might it hold crap?
Buy yourself a cone cutter and it will open up the holes easily enoughferris wrote:I didn't want to keep it as a solid piece because i thought if i didn't fully seal it properly it might fill with water over time and rust from the inside out. I thought if i filled it with holes that 1) i could spray paint in there 2) Any crud would just drain straight back out again. I did intend for the holes to be bigger but i only had a 10mm drill bit.