Page 3 of 5
Re: steering Z bar
Posted: Fri Oct 04, 2013 11:34 am
by Christoff
Sounds a bit of a bodge really tbh. Something as critical as steering. I would spend the £200 on a proper kit but if there's a perfectly good cheap alternative then I would do that instead.
Re: steering Z bar
Posted: Fri Oct 04, 2013 12:57 pm
by Christoff
Doesn't matter. Spoke to rob storr today and ordered one.
Re: steering Z bar
Posted: Fri Oct 04, 2013 10:19 pm
by Darrell
you got hold of him already
Sorted
Re: steering Z bar
Posted: Fri Oct 04, 2013 11:13 pm
by Christoff
Just answered the phone as normal. Don't know what your on about haha.
Re: steering Z bar
Posted: Mon Nov 17, 2014 9:57 pm
by donkeychomp
Aha so RS Engineering is Rob. I'm going to call him too, think I need one of these on the LJ, hit a pebble and it's all over the place.
Re: steering Z bar
Posted: Mon Nov 17, 2014 10:02 pm
by Boyes
Christoff, did you get locking nuts for the track rod ends in your robb storr kit? I've got mine but no locking nuts for the track rods, so nothing to stop them moving/adjusting themselves.
Re: steering Z bar
Posted: Fri Nov 21, 2014 10:32 pm
by donkeychomp
Well I called him and he answered!
Kit arrived but no instructions and I'm shaking my head at how to fit this. Going to call him back!
Re: steering Z bar
Posted: Fri Nov 21, 2014 11:38 pm
by Ladaman
Your lucky.
I just got my full float kit, eventually, and the shafts are just bits of tube with a thread tapped in each end.
They haven't been machined to my mind.
I did get the machined adaptors though.
Re: steering Z bar
Posted: Fri Nov 21, 2014 11:43 pm
by ScottieJ
Ladaman wrote:Your lucky.
I just got my full float kit, eventually, and the shafts are just bits of tube with a thread tapped in each end.
They haven't been machined to my mind.
I did get the machined adaptors though.
Eh??? You sure he hasn't sent you steering arms? Get a pic up??
Re: steering Z bar
Posted: Sat Nov 22, 2014 12:57 am
by Anton
Tube??? In a full float kit???
This full float kit???