Suzuki Club UK

Thanks for that Scott . I'll make some enquiries about getting some 413 shafts made. If its going to cost loads more i'l just go with the sammy axle, a inch and a half each side is not going to be very noticable.

I am having fully floating axles made for my Suzuki by rock watt

I doubt you will be able to get hold of Rs mfg !! But his stuff is very good.

Mike

Had mine deliverd today from rs mfg to be fair to him i orderd and they arrrived two days later even called me up to say thanks for the order. kit looks well made aswell

dannytrigger wrote:Had mine deliverd today from rs mfg to be fair to him i orderd and they arrrived two days later even called me up to say thanks for the order. kit looks well made aswell

Can I ask, how much the kit cost?

£250 inc vat and postage. but they do look vry well made i will run them a few times and see how i get on then post on here if that helps?

I have also just ordered fully floating rear, 26 spline front shafts and CV's, two diff lockers, high stearing kit, solid diff spacers and transfer box guard. Haveing to wait for the fronts to be made but will be worth it. Looks like quality products. I will do a build thread when I reseve all the bits. Cant wait.

chazz_543 wrote:I have also just ordered fully floating rear, 26 spline front shafts and CV's, two diff lockers, high stearing kit, solid diff spacers and transfer box guard. Haveing to wait for the fronts to be made but will be worth it. Looks like quality products. I will do a build thread when I reseve all the bits. Cant wait.

Bet that was an expensive shop.

Bet that was an expensive shop.[/quote]

It wasnt cheap but I do think fairly priced. Just cant wait to get building now got all the parts ready, its going to be one hell of a truck.