Page 2 of 3
Re: Starting problems ????
Posted: Tue Dec 09, 2014 7:30 pm
by lukey4x4
I think someone mat have cut it off cos av got nout is it on the same loom as everything els mate
Re: Starting problems ????
Posted: Wed Dec 10, 2014 8:46 am
by ROBBIE
Is it not just an earth wire to the bulkhead?
Re: Starting problems ????
Posted: Wed Dec 10, 2014 4:07 pm
by lukey4x4
This it what i was reading underneath theat picture ,
Re: Starting problems ????
Posted: Wed Dec 10, 2014 4:16 pm
by ROBBIE
Only had 1 wire on mine

Re: Starting problems ????
Posted: Wed Dec 10, 2014 4:30 pm
by lukey4x4
Orighty , well i will try it to see if it sorts the problem out , cos i dont have a clue lyk
Re: Starting problems ????
Posted: Wed Dec 10, 2014 5:49 pm
by ROBBIE
lukey4x4 wrote:Orighty , well i will try it to see if it sorts the problem out , cos i dont have a clue lyk
Hope it goes well

Re: Starting problems ????
Posted: Wed Dec 10, 2014 6:24 pm
by lukey4x4
Thanks mate me to lol
Re: Starting problems ????
Posted: Wed Dec 10, 2014 9:01 pm
by Rhinoman
The wiring has changed over the years, you should be able to see if any wires have been cut off, there should be at least one.
Re: Starting problems ????
Posted: Wed Dec 10, 2014 9:30 pm
by lukey4x4
Ok thanks mate , am off work tomoz so will be checking then , when i put the loom round engine bay i double checked n there were no wires left so probs bin cut off lyk
Re: Starting problems ????
Posted: Thu Dec 11, 2014 6:47 pm
by lukey4x4
Managed to track down the missing wires that were taped up to the loom connected them up n. Fired right up without cutting out after turning key back so problem sorted , thanks for the help