Starts at the flywheel, ends at the hubs, any problems along them lines, ask your questions here.
-
ScottieJ
- The Boss

- Posts: 11705
- Joined: Tue Apr 15, 2008 12:13 pm
- Location: Chippenham, wiltshire
Post
by ScottieJ » Mon Sep 02, 2013 4:56 pm
stock arches would cover those enough to not attract any attention dazerade
we used to run this arround and never had any attention, it was mostly sidewall that stuck out from the arch though, these are 235/75r15s on 7" wheels as well.
I didn't drive around for long with these sticking out though
I had to extend them a bit

-
turbo-tom
- I spend far too much time on here

- Posts: 4478
- Joined: Fri Jun 25, 2010 9:29 pm
- Location: West Sussex
Post
by turbo-tom » Mon Sep 02, 2013 7:31 pm
I meant to ad the disco aswell! well when we use to drive the suzuki on the road!

Tom
Ford Fiesta ST

-
Sj410red
- Engaged 4wd low

- Posts: 121
- Joined: Sun Sep 01, 2013 1:54 am
- Location: Clacton on sea, Essex
-
Contact:
Post
by Sj410red » Wed Sep 04, 2013 5:34 pm
Thanks very much for all your replies, I think I will leave it as it is for now, as it looks good, plus only 1 side is really an issue on the rear, fronts are even less, thanks for pic dazerede, mines no more than yours.
3" calmini lift springs
6" shackles
Rough Country Shocks
Z bar
32mm spacers
Aisan free wheeling hubs
Roll bar
Snorkel
K&N air filter
Poly bushes all round
Diff & Box high breather pipes
Front Diff guard
-
dazerede
- Suzuki, will you marry me?

- Posts: 2141
- Joined: Fri Sep 30, 2011 10:23 pm
- Location: cornwall callington
Post
by dazerede » Wed Sep 04, 2013 6:49 pm
But I have put some rubber on them naw
If it was just a offroad and greenlaning toy I wouldnt have the rubber bits on as it looks better
But I have to drive to college in.it as this is my daily drive
-
Attachments
-

- IMAG0093.jpg (827.04 KiB) Viewed 6266 times
Suzuki Sj 410 Jap Built
Recaro Seats Fitted
Landini Blue Colour
Full rollcage and winch bumper
1.6 8v vitara lump with su carb
4” calmini lift kit
235/75/15 insa turbo special tracks
99.9% Rust Free
BUILT NOT BOUGHT
-
Sj410red
- Engaged 4wd low

- Posts: 121
- Joined: Sun Sep 01, 2013 1:54 am
- Location: Clacton on sea, Essex
-
Contact:
Post
by Sj410red » Wed Sep 04, 2013 9:29 pm
Yeah it look good, nice paint too
3" calmini lift springs
6" shackles
Rough Country Shocks
Z bar
32mm spacers
Aisan free wheeling hubs
Roll bar
Snorkel
K&N air filter
Poly bushes all round
Diff & Box high breather pipes
Front Diff guard
-
Jordi
- Bow down before me

- Posts: 7540
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Post
by Jordi » Wed Sep 04, 2013 9:37 pm
I'm saying nothing.

- With spacers
- image.jpg (275.85 KiB) Viewed 6259 times

- Without spacers
- image.jpg (217.49 KiB) Viewed 6258 times
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
-
Sj410red
- Engaged 4wd low

- Posts: 121
- Joined: Sun Sep 01, 2013 1:54 am
- Location: Clacton on sea, Essex
-
Contact:
Post
by Sj410red » Fri Sep 06, 2013 8:46 pm
Nice tyres jordi, do you use the truck on the road with them like that?
Anyone else got some pics of their tyres to post?
3" calmini lift springs
6" shackles
Rough Country Shocks
Z bar
32mm spacers
Aisan free wheeling hubs
Roll bar
Snorkel
K&N air filter
Poly bushes all round
Diff & Box high breather pipes
Front Diff guard
-
windsor
- Winching along now

- Posts: 618
- Joined: Fri May 17, 2013 7:58 am
- Location: derbyshire
Post
by windsor » Fri Sep 06, 2013 9:02 pm
Av tried a few setups when desided what wheels and tyers am gunna keep on mine
-
Attachments
-

- They stick out buy just over 5inch
- 20130901_142936.jpg (2.7 MiB) Viewed 6239 times
-

- And theres no tyer under the arch with them wheels fliped rims and 32mm spaces
- 20130818_194756.jpg (3.07 MiB) Viewed 6239 times
1994 sj 413 sierra
cheker plate door cards
cd players
asin free wheeling hubs
99% rust free
alloys
bukets
some leaks here and there
-
dndnk
- Got muddy boots

- Posts: 62
- Joined: Fri Feb 25, 2011 8:17 pm
- Location: Warwickshire
Post
by dndnk » Mon Sep 09, 2013 10:13 pm
i think the law is as long as an effort has been made to cover them you will be ok . not sure really think its only from above it applies as well
-
Jordi
- Bow down before me

- Posts: 7540
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Post
by Jordi » Mon Sep 09, 2013 10:17 pm
Sj410red wrote:Nice tyres jordi, do you use the truck on the road with them like that?
Anyone else got some pics of their tyres to post?
I don't run the spacers on it, the bearings suffer enough as it is. So the tread sticks out about 1.5" i think and it's used on the road quite a bit.
The spacers will now be going onto my pickup with my old 31s on

1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank