Newbie looking to learn some things

The place to socialise, and relax, if it doesn't fit into anything below it fits here, so tell us that joke, or share that story of your last off-road escapade, but remember new comers the virtual drinks are on you!
User avatar
AshR1
Got muddy boots
Got muddy boots
Posts: 74
Joined: Thu Jul 18, 2013 3:26 pm
Location: South East Kent

Newbie looking to learn some things

Post by AshR1 » Thu Aug 29, 2013 1:48 pm

As title described im a newbie should be getting myself an sj end of September possibly sooner, I'm just looking for info on anything and everything really, I'm thinking of greenlaning in future and i want to just get opinions on a few things, I've been looking at a few modification parts and seen a calmini 3inch lift kit, has anybody used this before or could recommend something better? Or what things would be appropriate for greenlanong without going OTT on everything and make it ridiculous lol


Thanks

Ash
A Newbie with a 1988 Samurai Hard-Top

User avatar
ScottieJ
The Boss
The Boss
Posts: 11620
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: Newbie looking to learn some things

Post by ScottieJ » Thu Aug 29, 2013 2:01 pm

:welcome: to :suzuki: club

You don't need much to make an SJ capable.

I would avoid the calmini 3" shackle reverse lift kit, it limits the tyre size that you can run.

For a capable and reliable green laner all you really need is a

2" spring lift, llama 4x4 do nice springs
Some 30/31" mud terrain tyres
a snorkel (or avoid deep water)
extended axle and transmission breathers (essential!)

Good tow points front and rear and some recovery gear and you'll be sorted
Zuki Build

Steady as she goes!

User avatar
Edweird
Suzuki, will you marry me?
Suzuki, will you marry me?
Posts: 2531
Joined: Sat Jan 23, 2010 11:04 pm
Location: Brigg, North Lincolnshire

Re: Newbie looking to learn some things

Post by Edweird » Thu Aug 29, 2013 3:31 pm

They're surprisingly capable as standard though, even on road tyres.
Attachments
2013-08-17-1079.jpg
2013-08-17-1079.jpg (820.57 KiB) Viewed 5692 times
IMGP8047.JPG
IMGP8047.JPG (5.54 MiB) Viewed 5692 times
IMG_0213.JPG
IMG_0213.JPG (4.01 MiB) Viewed 5692 times
There's three ways of doing things:

The right way,
The wrong way
And my way, which is like the wrong way but faster.

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Newbie looking to learn some things

Post by Jordi » Thu Aug 29, 2013 3:54 pm

As said.

In standard form they are very capable in standard form. Dependin on your ability and it's condition you can cut the body work to fit 31" tyres to keep the cost down. A lot of use have done this as most SJs are rotten around the arches.

31s are a good side for most stuff but the gearin on a standard 413 is quite high for them so a 410 transfer box is a good idea for any tyres much over 29".

Snorkels can be anything from £40 for a DIY job to well over a £100 for a bespoke custom job.

The little 1.3 engines are more than capable on 31s so long as the gearing is right.

A few decent recovery strops and shackles and you're good to go.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
timwilks13
SCUK Website Padawan
SCUK Website Padawan
Posts: 1248
Joined: Sun Feb 03, 2013 5:55 am
Location: Scarborough, soon to be Poland

Re: Newbie looking to learn some things

Post by timwilks13 » Thu Aug 29, 2013 3:56 pm

£40 for a home made snorkel? Bit of silicon and homebase drain pipe, flebay cone filter and flexipipe, made mine for about £18!
1986 SJ410 - Furry dice, new window winder.

10 kinds of people in this world, those who understand binary and those who dont.

if you can read this you're too close to the monitor, sit back and save your eyes!!
My build, formally Trotters build.

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Newbie looking to learn some things

Post by Jordi » Thu Aug 29, 2013 4:31 pm

timwilks13 wrote:£40 for a home made snorkel? Bit of silicon and homebase drain pipe, flebay cone filter and flexipipe, made mine for about £18!
Your a frugal shopper Tim. Mine was technically free! :tongue:
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Newbie looking to learn some things

Post by turbo-tom » Thu Aug 29, 2013 4:36 pm

a good set of mud terrains and good front and rear recovery points and i recon you will be impressed on how far it can get.
Tom :)

Ford Fiesta ST :D

User avatar
timwilks13
SCUK Website Padawan
SCUK Website Padawan
Posts: 1248
Joined: Sun Feb 03, 2013 5:55 am
Location: Scarborough, soon to be Poland

Re: Newbie looking to learn some things

Post by timwilks13 » Thu Aug 29, 2013 4:39 pm

I wouldnt say i was overly frugal, but having said that i have my canadian girlfriends dad collecting my new nexus 7 from canada, bringing it to paris to give to my young lady, who will then bring it to me when i meet her in ireland, all to save £50....i guess thats kinda frugal lol.

On an SJ note, all the ones that came to wagtail as standard did incredibly well, obviously the bigger tyres, flex etc do make a difference, but if you just want to get out and do some mild off roading even throwing on some AT 195's would make a difference!
1986 SJ410 - Furry dice, new window winder.

10 kinds of people in this world, those who understand binary and those who dont.

if you can read this you're too close to the monitor, sit back and save your eyes!!
My build, formally Trotters build.

User avatar
donkeychomp
I spend far too much time on here
I spend far too much time on here
Posts: 3582
Joined: Thu Aug 18, 2011 3:49 pm
Location: Shepperton, Middx

Re: Newbie looking to learn some things

Post by donkeychomp » Thu Aug 29, 2013 9:57 pm

You have a Canadian girlfriend too? Join the (small) club!
If it ticks over...leave it

User avatar
Ladaman
Suzuki Guru
Suzuki Guru
Posts: 1090
Joined: Thu Sep 08, 2011 10:56 pm
Location: Huddersfield, W. Yorkshire
Contact:

Re: Newbie looking to learn some things

Post by Ladaman » Thu Aug 29, 2013 10:14 pm

As some of the others have said, you don't need many mod's for green laning.

I've only got smallish tyres on now, about 28/29" dia, quite chunky tread though. And that gets in lots of places, and lanes tend not to get rutted up like P&P sites, so ground clearance isn't an issue.

I did fit a 410 transfer box, and that made quite a difference, it really helped the gearing with standard diff's going up and down hills on P&P sites, and on tricky lanes.

Just go and have some fun. It will amaze you as it is I'm sure.
YouTube
Ignis Sport 1.5 16V; Jimny gearbox, 410 transfer box; 5.125:1 Vitara diffs; rear Lockright, Rob Storr full float rear axle, rear discs, YJ springs, virtual lift, 31" Grizzly Claws, beadlock rims, +50mm LR arches, LED rear lights, LED roof spots, bucket seats, Luke harnesses, internal cage

Post Reply