Steering column popped out???
Steering column popped out???
Has anyone seen this before? the steering column that goes into the engine bay from the cab has popped out i think? i can pull it out even further than the picture shows.Anyone know whats going on? I can still steer fine and something is bolted to the steering wheel so im confused?
- Attachments
-
- photo 2(1).JPG (1.65 MiB) Viewed 6669 times
-
- photo 1(1).JPG (1.69 MiB) Viewed 6669 times
- Darrell
- Suzuki, will you marry me?
- Posts: 2988
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: Steering column popped out???
I can only assume the shear pins have gone?
This is designed to happen only in an accident.
This is designed to happen only in an accident.
2005-GV 1600se, "Hell" What do I know!
Re: Steering column popped out???
I take it its knackered then? or are these shear pins replaceable? I havent a clue! lol
- Darrell
- Suzuki, will you marry me?
- Posts: 2988
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: Steering column popped out???
If it is the shear pins , the manual says you have to replace the column.
These pins are quite hard to break I thought .
Somebody hopefully will have more advice if its the pins and if you can replace them.
These pins are quite hard to break I thought .
Somebody hopefully will have more advice if its the pins and if you can replace them.
2005-GV 1600se, "Hell" What do I know!
Re: Steering column popped out???
Ok mate thanks! I'm guessing its to dangerous to drive? Or should it still be ok?
- Darrell
- Suzuki, will you marry me?
- Posts: 2988
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: Steering column popped out???
I must admit I can't understand why the column has come out at the bottom so much. I would have though it couldn't as the steering joint bar and steering box would not allow it to.
I don't know if it's safe to drive , but I would guess not.
I don't know if it's safe to drive , but I would guess not.
2005-GV 1600se, "Hell" What do I know!
- dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: Steering column popped out???
The clean bit that has slid out from the bulkhead shouldnt be able to do that. I guess it must be on a sliding splined arrangement inside the cab. This shouldnt happen though. I certainly wouldnt drive it.
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
- turbo-tom
- I spend far too much time on here
- Posts: 4478
- Joined: Fri Jun 25, 2010 9:29 pm
- Location: West Sussex
Re: Steering column popped out???
Your meant to have the bolt in the centre of the wheel. As the steering wheel is splined.
Tom
Ford Fiesta ST
Ford Fiesta ST
Re: Steering column popped out???
Yeah I was just showing that something is bolted to the steering I just don't know what the setup is meant to look like assembly wise?
- turbo-tom
- I spend far too much time on here
- Posts: 4478
- Joined: Fri Jun 25, 2010 9:29 pm
- Location: West Sussex
Re: Steering column popped out???
Yeah I get you steering wheel end all looks okay buddy.
Tom
Ford Fiesta ST
Ford Fiesta ST