this is kind of suzuki related because i cant get on with my anus untill ive sorted this stupid effing mini!!!!
Car was funning fine.
its on twin hif38 su's
took off the inlet manifold to tighten up a compression fitting on the bottom of one of the carb reservoirs.
leak stopped so put the manifold back on and now it wont start
i have a spark. fuel pressure is ok. if i take off the pipes to the carbs and turn her over petrol sprays all over the road. if i spray fuel thru the carbs with a garden sprayer she runs.
just no life when trying to run with the carbs alone.
i know a few of you that have 410's are probably running hif38's. have any of you had this problem?
its as if moving or turning them upside down has caused a problem in the carbs but ive had them off before with no problems.
my mini
- dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
my mini
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Re: my mini
blocked jets or sticking floats maybe?
- dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: my mini
after i posted i checked floats. both ok. i cant see how removing the inlet manifold and putting it back on could cause a blockage but its looking like the next port of call!
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
- dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: my mini
i seems to only run under £1 service conditions (hands over air intake) Which would suggest serious under fueling!
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.