Tie rod to steering arm ball joint torque

Post your questions about your suspension and steering problems here!
Post Reply
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Tie rod to steering arm ball joint torque

Post by Jordi » Fri May 31, 2013 11:54 am

Fairly sure thats the right bit.

How tight should the ball joint castle nut be attaching the tie rod to the steering box?

Thanks
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
ScottieJ
The Boss
The Boss
Posts: 11618
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: Tie rod to steering arm ball joint torque

Post by ScottieJ » Fri May 31, 2013 12:08 pm

Zuki Build

Steady as she goes!

trotter
Winching along now
Winching along now
Posts: 617
Joined: Tue Apr 15, 2008 5:59 pm
Location: behind you

Re: Tie rod to steering arm ball joint torque

Post by trotter » Fri May 31, 2013 3:50 pm

:hahaha:
if in doubt, FLAT OUT!

mans tool kit > duct tape, wd40 and a bfh is all you ever need

Post Reply