33s Whoo Hoo!!!! They've ARRIVED!!!

The place to socialise, and relax, if it doesn't fit into anything below it fits here, so tell us that joke, or share that story of your last off-road escapade, but remember new comers the virtual drinks are on you!
Post Reply
Richie
Engaged 4wd low
Engaged 4wd low
Posts: 192
Joined: Fri Nov 09, 2012 6:23 pm

Re: 33s Whoo Hoo!!!!

Post by Richie » Wed Apr 17, 2013 11:15 pm

Ive smashed the bulk head and welded it alittle bit back but im 6 foot 4 and dont wanna lose any more leg room lol. Dunno if its true but im sure ive heard when u put rears on the front they move the axle foward about a inch anyways... Did u need a prop spacer?
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: 33s Whoo Hoo!!!!

Post by Jordi » Wed Apr 17, 2013 11:18 pm

http://forum.suzukiclubuk.co.uk/vi ... php?t=1545

Standard springs
image.jpg
image.jpg (621.92 KiB) Viewed 4871 times
Lifted
image.jpg
image.jpg (1.23 MiB) Viewed 4871 times
Best photos i could find. I have approx 5" clearance all the way round on 31s. No fouling at all. So 33s should be fine, i've also got extended bump stops to i dont kill my nice springs or rip the 1600 sump off when i fit it.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: 33s Whoo Hoo!!!!

Post by Jordi » Wed Apr 17, 2013 11:22 pm

I haven't moved the axle (yet). If i dont have to i probably won't. I'd probably need extended props (don't like spacers) and it would cock the castor up so i'd need shims or small lift shackles to correct it.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
User avatar
ScottieJ
The Boss
The Boss
Posts: 11620
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: 33s Whoo Hoo!!!!

Post by ScottieJ » Wed Apr 17, 2013 11:23 pm

You won't loose any leg room ;) you only need to cut out the section behind the throttle pedal and remove the stop for it so the pedal just ends up being stopped by the new section that you weld in.

This is cut out enough to clear 33s with standard height suspension.

Image

You won't even notice the difference!
Zuki Build

Steady as she goes!
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: 33s Whoo Hoo!!!!

Post by Jordi » Wed Apr 17, 2013 11:24 pm

Richie wrote:Ive smashed the bulk head and welded it alittle bit back but im 6 foot 4 and dont wanna lose any more leg room lol.
Remount the seat further back.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: 33s Whoo Hoo!!!!

Post by Jordi » Wed Apr 24, 2013 10:33 pm

Ok, took longer than expected. Just order four GT Radial Adventuro M/Ts 33/12.50/15s.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
upjakscreek
Got muddy boots
Got muddy boots
Posts: 44
Joined: Thu Apr 18, 2013 10:25 pm
Location: north london

Re: 33s Whoo Hoo!!!!

Post by upjakscreek » Wed Apr 24, 2013 11:33 pm

Nice, you putting these on the new wheels? How will the offset work for you?

Neil
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: 33s Whoo Hoo!!!!

Post by Jordi » Thu Apr 25, 2013 2:37 am

Got some off set 15x10s for them. Also got wheel spacers.

So it should look pretty fat.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: 33s Whoo Hoo!!!! They've ARRIVED!!!

Post by Jordi » Fri Apr 26, 2013 5:32 pm

Stood next to a standard rim.
image.jpg
image.jpg (1.65 MiB) Viewed 4806 times
Tread
image.jpg
image.jpg (2.07 MiB) Viewed 4806 times
Sidewall
image.jpg
image.jpg (1.99 MiB) Viewed 4806 times
I was supposed to do a width comparison photo against standard too but forgot.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
User avatar
ScottieJ
The Boss
The Boss
Posts: 11620
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: 33s Whoo Hoo!!!! They've ARRIVED!!!

Post by ScottieJ » Fri Apr 26, 2013 6:00 pm

:rockin: can you let me know the true height once they are fitted? I'm tempted to sell the buckshots.
Zuki Build

Steady as she goes!
Top
Post Reply

Return to “The Bar”