Me second Zuke

Got an vehicle build underway? post up pictures and tell us all how its going!

Builds threads only please.
User avatar
Crisdolf
Engaged 4wd low
Engaged 4wd low
Posts: 101
Joined: Thu Aug 09, 2012 10:48 am
Location: Herefordshire

Me second Zuke

Post by Crisdolf » Mon Mar 04, 2013 7:57 pm

Just brought me 2nd Zuke a 413 this time towed it home as no battery ,and ideas what I should do before trying to start it ?
Attachments
image.jpg
image.jpg (116.19 KiB) Viewed 7396 times
image.jpg
image.jpg (104.41 KiB) Viewed 7396 times
Sj413 Vx 1986
2" lift
30mm Spacers
215x15
Inner roll cage
Winch
Driven with a Smile

User avatar
Crisdolf
Engaged 4wd low
Engaged 4wd low
Posts: 101
Joined: Thu Aug 09, 2012 10:48 am
Location: Herefordshire

Re: Me second Zuke

Post by Crisdolf » Mon Mar 04, 2013 7:57 pm

It's been stood a couple of years
Sj413 Vx 1986
2" lift
30mm Spacers
215x15
Inner roll cage
Winch
Driven with a Smile

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Me second Zuke

Post by turbo-tom » Mon Mar 04, 2013 7:59 pm

give the engine, drivetrain and brakes a good look over, clean out the brakes etc bleed them, service the engine, replace all the oils and fluids give it a clean and then go from that , thats what i would doo ;)
Tom :)

Ford Fiesta ST :D

User avatar
Crisdolf
Engaged 4wd low
Engaged 4wd low
Posts: 101
Joined: Thu Aug 09, 2012 10:48 am
Location: Herefordshire

Re: Me second Zuke

Post by Crisdolf » Mon Mar 04, 2013 8:09 pm

Will the carb need draining ? I heard the cards on theses are a pain ?
Sj413 Vx 1986
2" lift
30mm Spacers
215x15
Inner roll cage
Winch
Driven with a Smile

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Me second Zuke

Post by turbo-tom » Mon Mar 04, 2013 8:13 pm

what carb is on it mate?
Tom :)

Ford Fiesta ST :D

User avatar
ScottieJ
The Boss
The Boss
Posts: 11680
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: Me second Zuke

Post by ScottieJ » Mon Mar 04, 2013 8:22 pm

If its been sat a long time I always pull the plugs and pour a bit of oil into each cylinder, enough to coat the top of the piston, then loosely fit the plugs (1-2threads) to stop any crap getting in and leave it to sit for a few days so the oil can settle. Pull the plugs back out and turn it over by hand a good few times and shine a torch in each cylinder to make sure all the oil has cleared, refit plugs and give it a few turns over by hand. Add some fresh fuel, check oil/water etc and fire her up.
Zuki Build

Steady as she goes!

User avatar
Crisdolf
Engaged 4wd low
Engaged 4wd low
Posts: 101
Joined: Thu Aug 09, 2012 10:48 am
Location: Herefordshire

Re: Me second Zuke

Post by Crisdolf » Mon Mar 04, 2013 8:48 pm

No idea what carb ,it's a auto choke that's all I know ,bit of engine oil for pistons ? Or something like 3in 1 oil ?
Sj413 Vx 1986
2" lift
30mm Spacers
215x15
Inner roll cage
Winch
Driven with a Smile

User avatar
OllieSJ
...
...
Posts: 0
Joined: Tue Feb 28, 2012 2:15 pm

Re: Me second Zuke

Post by OllieSJ » Mon Mar 04, 2013 8:52 pm

nice m8 were did u find it i havent seen it !
Sj410Q- Spacers, Bucket seats, Su carb , Mot and Tax

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7540
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Me second Zuke

Post by Jordi » Mon Mar 04, 2013 8:54 pm

Boggo standard oil, or duckoil. Something quite thin generally penetrates better.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
Crisdolf
Engaged 4wd low
Engaged 4wd low
Posts: 101
Joined: Thu Aug 09, 2012 10:48 am
Location: Herefordshire

Re: Me second Zuke

Post by Crisdolf » Mon Mar 04, 2013 9:52 pm

Bloke had it in his back yard for 4 yrs ,rust round arches and bit round screen but that's about it ,4 conways on it like new and if u see spare on back there's 4 of them too plus as a winch on the front,my plans are take the folding bench seat out the back replace soft top ( no leaks or splits) for hard top and go from there :)
Sj413 Vx 1986
2" lift
30mm Spacers
215x15
Inner roll cage
Winch
Driven with a Smile

Post Reply