1991 Santana Samurai

[tomcat]

Purchased a 7" lamp mounting set [usually for Mini, MGB et., which needed to be modified for the Samurai.

Cut the shell with a Dremel as near to the support ring as I could and then ground the edge down till almost flat.

[tomcat]

First stage, located outer ring positions for beam adjustment screws. 12mm diameter holes required. There are in addition 4 No fixing points.
After much measurement, remeasure, relocation drilled holes in stages, 3, 5, 8, 10mm and finished off with a file.

[tomcat]

A number of small jobs are ongoing. Mainly trying to resolve the wiring upgrades.
Am converting indicators to LEDS and upgrading headlights with relays.

[tomcat]

Bits of work been done. Nothing major mainly electrics.
Found windscreen washer had 2 pumps. Seems original was not replaced but inline pump put in. Outlet to that has snapped off and so I am sorting out replacement system.