My latest common sense failure

[Jordi]

Not sure if i like this, had an opinion off a few people and the general thought is “looks better”.

Black door bottoms.

[donkeychomp]

Had a zoom in on that bumper pic....looks fine to me matey. Satin black, you can't really go wrong with it.

If you want the bumper a tad straighter lift the back end up with a bottle jack whilst standing on the front of it. Might shift it a few mm.

[Jordi]

Its just a fibre glass bumper Alex, zero strength to jack it or stand on it.

I did square the mounts a bit more, also added some big washers to the top bolts. A lot straighter than it was.

Next time I remove it i’ll add a few more washers.

Tomorrows aim is a spare wheel carrier and new number plate mount for the rear.

[Jordi]

I said spare wheel mount, had a look at a few options and then realised it would fit here.

Fits inbetween the chassis rails on two cross members, at the moment i have just put a ratchet strap hooked onto the chassis to hold it.

See if it moves / rubs, think it will probably need some locators welding on to prevent movent.

[donkeychomp]

Rust? I don't see any rust, no no, none at all

[Jordi]

Rust? I don't see any rust, no no, none at all

Nothing too serious that wont come me out with an abrasive disc.

Etch primer and gloss black rattle cans on order.

[donkeychomp]

I know mate. Will look very neat when all done. I reckon a cheap set of alloys are in order...