Sourcing a rear propshaft

Starts at the flywheel, ends at the hubs, any problems along them lines, ask your questions here.
Post Reply
User avatar
portaccio
Got muddy boots
Got muddy boots
Posts: 8
Joined: Thu Nov 20, 2014 4:15 pm
Location: Keynsham, Bristol

Sourcing a rear propshaft

Post by portaccio » Tue Apr 24, 2018 5:38 pm

Hi, it's been a long time since I've needed to ask for advice from this forum. Just goes to show how little trouble my Jimny has given me over the years.
I have a vibration caused by my rear propshaft and my mechanic has handed my car back saying he couldn't find one, and if I can find one online he'll fit it for me.

I've got a 2002 JLX Special and cannot find anything in the generic car part websites. I have found this...

https://www.motorhog.co.uk/parts-breaki ... /1/728776/

...which is from 98 automatic. Will that make any difference that mine is a manual? Sorry, I have absolutely zero mechanical knowledge.

Can anyone point me in the direction of someone who could help me source what I need?

Regards
Tom

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7534
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Sourcing a rear propshaft

Post by Jordi » Tue Apr 24, 2018 8:03 pm

Probably just a universal joint.

What part of the prop did he say was worn?
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
zook123
SCUK Addict
SCUK Addict
Posts: 948
Joined: Sun Apr 20, 2008 10:48 pm
Location: Shepton Mallet

Re: Sourcing a rear propshaft

Post by zook123 » Wed Apr 25, 2018 3:07 pm

What type of vibration is it?
Image
2002 Jimny O2 Ragtop
Safari Snorkel, Freewheeling Hub Conversion
Diff Breathers, G/Box and T/Box Breathers, 2in Suspension Lift
HD Recovery Points and Winch Plate
Kuhmo KL71 MT / Goodyear Wrangler AT


Wessex 4X4 Reponse - WE411
wessex4x4response.org.uk

User avatar
zook123
SCUK Addict
SCUK Addict
Posts: 948
Joined: Sun Apr 20, 2008 10:48 pm
Location: Shepton Mallet

Re: Sourcing a rear propshaft

Post by zook123 » Wed Apr 25, 2018 3:09 pm

Might be worth dropping the props and checking the UJ's, the vibration that was really bad for me was caused my the transfer box mounts!
Image
2002 Jimny O2 Ragtop
Safari Snorkel, Freewheeling Hub Conversion
Diff Breathers, G/Box and T/Box Breathers, 2in Suspension Lift
HD Recovery Points and Winch Plate
Kuhmo KL71 MT / Goodyear Wrangler AT


Wessex 4X4 Reponse - WE411
wessex4x4response.org.uk

User avatar
ROBBIE
I spend far too much time on here
I spend far too much time on here
Posts: 4555
Joined: Tue Sep 09, 2008 6:32 pm
Location: Dorset or stuck

Re: Sourcing a rear propshaft

Post by ROBBIE » Wed Apr 25, 2018 4:41 pm

Would say uj as well. I’ve had the slide joint go and that just goes bang, bang, bang and so on
Sid James gone but never forgotten
Jimny 1.6 not as good as an SJ but still good

User avatar
zook123
SCUK Addict
SCUK Addict
Posts: 948
Joined: Sun Apr 20, 2008 10:48 pm
Location: Shepton Mallet

Re: Sourcing a rear propshaft

Post by zook123 » Thu Apr 26, 2018 10:56 am

I've got a spare rear propshaft that will fit yours and i'm in Shepton. You're more than welcome to pop down and try the spare prop out and see if it fixes it?
Image
2002 Jimny O2 Ragtop
Safari Snorkel, Freewheeling Hub Conversion
Diff Breathers, G/Box and T/Box Breathers, 2in Suspension Lift
HD Recovery Points and Winch Plate
Kuhmo KL71 MT / Goodyear Wrangler AT


Wessex 4X4 Reponse - WE411
wessex4x4response.org.uk

Post Reply