Project KJA

[ianedwards]

I like it, they are just 15mm copper pipe clips. Couldn't think of any where else to put it without it looking stupid lol

I was thinking it might be the choke, so is it a rebuild kit or a service kit I need, ?
Plus do you think the bdl needle will be ok.

[Anton]

Great idea - I might have to knick the idea, as my front recovery point position kinda means I might crush the number plate with my recovery rope...

And one day I might fit my winch. It's kinda just sitting around waiting to get some love...

[ianedwards]

Morning

Anton Spend the time on it, fit it you never know you may need it one day.


I've ordered a gasket/seal kit, and a bfm needle and some damper oil. Just got to wait for them to come now, hopefully by this time next week I'll have it running tidy.. Fingers crossed

Cheers

[kiwizook]

What oil did you order for the damper oil?

[ScottieJ]

What oil did you order for the damper oil?

Probably proper SU oil. Any straight sae20 weight oil should work though.

[ianedwards]

Yea I bought it from burlen, might as well as I Got the seals from there.

[ianedwards]

evening

been busy working on my spare carb, stripped cleaned and changed all the seals and oil and new needle.

IMG_0224.jpg (73.31 KiB) Viewed 8405 times

carb all sorted and changed over.

IMG_0226.jpg (96.47 KiB) Viewed 8405 times

just a closer view, bit cleaner than the old one

IMG_0230.jpg (95.08 KiB) Viewed 8405 times

fired her up, took a while to fill it up, but once she started and a bit of tweaking, much much better.

and with a bit more tuning with a colour tune, i had the flame nice and blue.

my dad is going to trailer it up to his on the weekend, so i can drive it round his place for a bit, give it a bit of a run in, make sure it's all ok and finish a few little things off. then hopefully everythings ok and he will drop it in for mot early next week.

[donkeychomp]

Superb work, can't fault anything.

[RickUK]

Really enjoyed reading this thread,perfectionist is the word that i would use

[ianedwards]

Cheers chaps.

Right

Been driving it round this afternoon and I've got it running pretty nice.

But to me as your driving along going up through the gears I can still feel I touch of what I would describe as a regular hesitation. Only when the engines under load, not if your just sat there revving it. Also it takes a while to settle back down to idle.

Any ideas, I've been through everything now, it's a lot better but still not 100% I don't think. Or am I expecting to much as I've never driven one before.
Cheers.