Any idea what rims these are?

[Anton]

[gamble63]

see on jimny bits it says

"These wheels look great on a Suzuki and the -30 offset is for those who want a wide stance without fitting wheel spacers"

but looking at your image it makes it look like we want a positive offset?

or am i looking at it wrong?

these were some old sj wheels i had and im guessing they are 0 offset



Cheers

[Anton]

In that image the inside face of the wheel is on the left, the outside face is on the right. So -30 means that the wheels would stick out an extra 30mm further than 0 offset. Similar to getting 30mm spacers.

Bear in mind that if the rims are wider than the ones they replace, then 0 offset rims will stick out a bit further anyway.

[gamble63]

ah that makes sense, thanks Anton, i will measure tomorrow and if all is good will order them

hopefully problem solved.

Thanks guys

[gamble63]

lol naturally they only have 1 in stock haha

[gamble63]

Hey guys had a quick measure of the wheels on the truck today, i think i measured it from the right place and was getting 8" width and that i think is a 30mm offset. i know jimny bits sell 7" wide with the 30mm offset but i cant find any 8" wide, if i run with the 7" wheel is that going to be ok with the 31"x10.5x15?







Thanks guys

[ScottieJ]

You measure the wheel width from the inside of the lips so if it's 8" outside edge to outside its gonna be a 7" wheel.

[12callum]

Pretty sure I've got a set of 5 of these wheels I'll try and find a photo!

[gamble63]

ah thanks Scottie that is great news, Callum im after 2 of them so that would ruin your set of 5. if you do have the same size with the 30mm offset and want to sell 1 id buy one from you and one from jimny bits.

cheers guys


edit** jimny bits are out of stock at the mo, dammit